Expert Electronics SunSDR2 DX - Included Accessories List

7
SunSDR2 DX User Manual
© 2020 Expert Electronics
READ IT FIRST
· TCI interface for seamless connection with third-party software, the list of software with TCI
support is published on our website
· Professional TX processing module provides the most advanced tuning capability for
voice operation
· ExtCTRL connector to control external devices with 8 powerful keys with open collector
· ALC connector for external power amplifiers*
· Supports use of VHF transverters*
· An opportunity to use the transceiver as a signal generator via DAC OUT connector (SMA
connector)
· An opportunity to use external filters in the middle of the RF path, using ADC IN and RX
OUT (SMA connector)
· A small delay in CW mode (about 10 ms)
· Input for external 10 MHz reference oscillator
· An opportunity to use the transceiver in SO2V mode
· Full duplex or half duplex modes*
· Antenna switch with 2 HF antenna connectors and separate VHF antenna connector (Mini
UHF connectors)
· Internal power-meter for HF and VHF bands and SWR-meter for HF band
· Ethernet LAN interface provides a fast and reliable connection to PC
* These functions are supported by the transceiver's hardware, but is not implemented in the
ExpertSDR2 software. They will be supported in the future ExpertSDR software releases.
Minimal PC requirements
· CPU Intel Core i3 / Core i5 or better
· 8GB RAM
· Video card, minimum resolution 1024x600, 128 MB, OpenGL 1.5 support and higher
· The ExpertSDR2 works with Windows 7-10 32/64 bit, Linux (Ubuntu/Kubuntu 20.04 LTS x64)
and macOS 10.15 and newer
Block Diagram will be available later.
1.3 Supplied accessories
· SunSDR2 DX transceiver
· External fan fastened to the heatsink, size 140 x 140 mm
· LAN-cable for connection to a local network (1.8m)