EasyManuals Logo

Extreme Networks ExtremeSwitching X440-G2 Series User Manual

Extreme Networks ExtremeSwitching X440-G2 Series
413 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #243 background imageLoading...
Page #243 background image
Figure 189: STK-RPS-150PS Installation in an STK-RPS-150CH8 Shelf
1 = STK-RPS-150CH8 shelf
3 = Captive screws (2)
2 = STK-RPS-150PS power supply 4 = Shelf power supply slot
3 Fasten the power supply to the RPS shelf using the captive screws on the PSM front panel.
4 Repeat the two previous steps for each additional power supply.
5 Proceed to Installing the RPS Shelf into the Rack on page 243.
Installing the RPS Shelf into the Rack
To install an STK-RPS-150CH2 or STK-RPS-150CH8 into a 19-inch (48.3 cm) rack, you need the following:
For the STK-RPS-150CH2: four customer-supplied screws to fasten the shelf to the rack rails.
For the STK-RPS-150CH8: ten customer-supplied screws to fasten the shelf to the rack rails.
After installing the power supplies as described in Installing an STK-RPS-150PS in an RPS Shelf on page
242, rack mount the RPS shelf as follows:
1 Refer to the installation guidelines (Guidelines for Rack Mount Installation).
2 Install the RPS shelf into the rack (Rack Mounting the RPS Shelf on page 244).
3 Connect the RPS cables and AC power cords of the power supplies (Connecting the RPS Cable and
AC Power Cord on page 246).
Installing External Power Supplies
ExtremeSwitching and Summit Switches: Hardware Installation Guide 243

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Extreme Networks ExtremeSwitching X440-G2 Series and is the answer not in the manual?

Extreme Networks ExtremeSwitching X440-G2 Series Specifications

General IconGeneral
Form FactorRack-mountable
VLAN SupportYes
Humidity5% to 95% non-condensing
ModelX440-G2 Series
Port TypeGigabit Ethernet
Switching Capacity176 Gbps
Forwarding Rate131 Mpps
StackingYes, up to 8 switches
Layer SupportLayer 2/3
Operating Temperature0°C to 50°C
Product TypeSwitch
Jumbo Frames9216 bytes
AC Power Supply100-240 VAC, 50-60 Hz
Storage Temperature-40°C to 70°C
Port Configuration24 or 48 ports
Power over Ethernet (PoE)Optional

Related product manuals