FAAC B680H - Programming the Board

B680H 29 732719 - Rev.E
Translation of the original instructions
ENGLISH
5.1 PROGRAMMING THE BOARD
When the display shows the automation status, you
can enter basic, advanced or expert programming
mode.
■ Basic programming
1. Press and hold the
FF button:
the first function (
C C) appears on the display,
which is displayed as long as button F remains
pressed.
2. Release the button: the display shows the value
of the function.
3. Press the
++ or
--
button to modify, then press the
FF button to confirm to go to the next function.
Proceed in the same way for all the functions.
■ Advanced programming
1. Press and hold the
FF button, then the ++ button
as well: the first function (
bo) appears on the
display, which is displayed as long as button FF
remains pressed.
2. Release the buttons: the display shows the value
of the function.
3. Press the
++ or
--
button to modify, then press the
FF button to confirm to go to the next function.
Proceed in the same way for all the functions.
■ Expert programming
i
Before making changes at this level, make sure that you
fully understand the effect that the changes might have.
If you modify functions relating to the operating logics,
a custom logic is created (in basic programming the LO
function will display CU).
1. Press and hold the
FF button, then the + + button
as well for about 10 seconds: the first function (
01)
appears on the display, which is displayed as long
as button FF remains pressed.
2. Release the buttons: the display shows the value
of the function.
3. Press the
++ or
--
button to modify, then press the
FF button to confirm to go to the next function.
Proceed in the same way for all the functions.
■ Exiting programming mode
i
Every modified value becomes effective immediately,
but when exiting from programming mode you have to
decide whether to save the modifications or not.
Modifications are lost if no buttons have been pressed
for 10 minutes or if power to the board is disconnected
before they have been saved.
1. Press and hold down the
FF button, then the
++
button as well.
Alternatively, scroll through the programming
menu until you reach the last function (
St).
2. Select:
Y = save the changes
no = DO NOT save the changes
3. Press button
FF to confirm: the display reverts to
the automation status view.