FAAC B680H - Battery XBAT 24 (J12); Power Supply 36 V; J13; Beam Lights 36 V

B680H 27 732719 - Rev.E
Translation of the original instructions
ENGLISH
BATTERY XBAT 24 J12
RED
BLACK
BLUE
BLACK
J12
Connect the emergency battery to this connector.
POWER SUPPLY 36 V
"
J13
J13
RED
BLACK
Pre-wired connector, used for powering the board.
i
The installer must connect the earth terminal to the
system earth during electrical connection operations.
BEAM LIGHTS 36 V
"
J16
GND
BLG
BLR
J16
The rope light indicates that the beam is moving. The
operation can be configured using parameters
o5 and
o6 and the light intensity via parameters dG and dr
in expert programming mode.
ENCODER J17
J17
The encoder wire is connected to connector J17 in
the factory.
i
The encoder must always be connected in order for the
automation system to operate.
INTEGRATED FLASHING TRAFFIC LIGHT J18
J18
The integrated flashing traffic light should be con-
nected to connector J18.
SIMPLY CONNECT M1  M1A  M2
M1
M2 M1A
Example with XMB module
Insert the module into the dedicated plug connectors
and install the Simply Connect PRO app.
i
When programming is taking place via Simply Connect,
programming from the board is inhibited.