FAAC B680H - Advanced Programming

B680H 32 732719 - Rev.E
Translation of the original instructions
ENGLISH
 4 Advanced programming
Advanced function Default
FO
DRIVING FORCE ON OPENING
01 minimum power
50 maximum power
*The default value varies according to the setting
of cF:
25 if cF=01 or 02
30 if cF= 03
28 if cF=04
30 if cF=05
40 if cF=06
40
*
FC
DRIVING FORCE ON CLOSURE
01 minimum power
50 maximum power
*The default value varies according to the setting
of cF:
25 if cF=01 or 02
30 if cF= 03
28 if cF=04
30 if cF=05
40 if cF=06
40
*
PF
PRE-FLASHING
no not enabled
OC enabled before opening and closing
CL enabled before closing
OP enabled before opening
PA enabled only at end of pause
no
tP
PRE-FLASHING TIME
00 minimum pre-flashing
10 maximum pre-flashing
00
oc
OBSTACLE SENSITIVITY DURING CLOSING
01 minimum sensitivity
50 maximum sensitivity
30
Advanced function Default
o1
OUTPUT OUT 1 CONFIGURATION
04
00 Failsafe
01 Type 1 beam lighting (on when beam closed,
off when beam is open or paused, flashing
when moving).
02 Type 2 beam lighting (flashing during ope-
ning, closing and when the beam is closed or
stopped. Off when beam is open or paused)
03 Beam closed
04 Beam open or paused, switches off during
closing pre-flashing.
05 Beam opening, including pre-flashing.
06 Beam closing, including pre-flashing.
07 Beam stopped
08 Beam in emergency
09 LOOP1 engaged
10 LOOP2 engaged
11 Open for secondary E680
12 Close for secondary E680
13 Beam breakthrough
14 Not used
15 Not used
16 Opening deceleration space engaged
17 Closing deceleration space engaged
18 Interlock
19 Indicator Light (on during opening and
pause, flashing during closing, off when
automation closed).
20 Battery operation
P1
OUTPUT POLARITY OUT 1
Y NC output
no NO output
If output o1 = 00 (Failsafe) configure P1 = no.
no
o2 see o1 03
P2 see P1 no
o3 see o1 19
P3 see P1 no
o4 see o1 01
P4 see P1 no
o5 see o1 02
P5 see P1 no
o6 see o1 04
P6 see P1 no