FAAC B680H - Start-Up and Board Programming

24
B680H 28 732719 - Rev.E

MOTOR
2EASY
3 4 5 6 7 8 9
11
10
12 13 14 15 16 17 18 19 2120 24 25 26 27
S.O.
RP/DECODER
CAL1 CAL2
SW1 SW2 SW3
DL9
DL13DL12
DL2
DL15
DL14
Translation of the original instructions
ENGLISH
5. STARTUP
Carry out the following operations referring to the §
specific sections.
1. Make sure that the barrier B680H is locked and not
operating in manual mode.
2. Switch on power to the system. The board lights
up and the display then comes on:
- firmware version (2 digits separated by a point).
-
SO flashing if setup is requested, or the automa-
tion status.
i
If two barriers are installed in a Primary-Secondary con-
figuration, the Secondary barrier has to be configured
before you start to set up the Primary barrier (see § 8.1).
3. Check the status of the LEDs, with the board pow-
ered and closed, some LEDs will be on, others will
be off (refer to 24)
4. Memorise the radio controls of the system (see
relative instructions).
5. Program the E680S without carrying out the set-
up. In order for the barrier to work properly, set
function
cF according to the length of the beam.
6. Check the direction of movement.
7. Carry out the setup procedure.
8. If you use an XBAT 24 battery, connect the battery
after having carried out the setup. Connect it
with the power supply disconnected.