FAAC B680H - Check Movement Direction and Setup

1
2
B680H 42 732719 - Rev.E
25
Translation of the original instructions
ENGLISH
5.4 CHECK THE DIRECTION OF MOVEMENT
1. Select parameter Mt in Basic Program-
ming: the display shows
--.
2. Press and hold the ++ button: the display shows
oP and the barrier opens. Press and hold the
--
button: The display shows cL and the barrier
closes.
3. If the conditions in points 2 and 3 are not met, dis-
connect the power supply and invert the black
and brown wires of terminal J5 without modify-
ing the central wire.
i
In the conditions indicated in points 2 and 3, the flashing
dot between the two letters indicates that the encoder
is operating correctly.
MOTOR
M
MOTOR
M
RH
BLACK
BLUE
BROWN
MOTOR
M
MOTOR
M
LH
BLACK
BLUE
BROWN