FAAC B680H - Installing Photocells on the Barrier

32
B680H 50 732719 - Rev.E
C
D
D
A
B
B
B
C
D
D
Translation of the original instructions
ENGLISH
7.3 INSTALLING PHOTOCELLS ON THE
BARRIER
1. Remove the cabinet.
2. Open the door A.
3. Determine which is the most suitable cable routing
hole B and mark it on the strip C from the inside.
4. Remove the strip C from the cabinet by removing
the fastening screws D.
5. Drill the hole for routing the cable.
6. Use the photocell fixing plate E to mark the fixing
holes and drill them.
7. Mount the photocell following the installation
instructions.
8. Feed the power cable through the cable routing
hole.
9. Connect the photocell following the wiring dia-
gram provided.
10. Reassemble the unit.