FAAC B680H - Limit Switch Adjustment

B680H 22 732719 - Rev.E
A
C
B

A
B
C
22
17
25 Nm
17
25 Nm

Translation of the original instructions
ENGLISH
3.6 LIMIT SWITCH ADJUSTMENT
1. Release the barrier.
2. Close the beam and keep it in this position.
3. Adjust the limit switch A until it is in contact with
the balancer arm B.
4. Use a spirit level to make sure that the limit switch
is correctly adjusted. Repeat the sequence if
necessary.
5. When finished, tighten the locknut C to the fasten-
ing torque indicated.
6. Repeat the adjustment procedure with the beam
open on the second limit switch.
7. Restore operation.