FAAC B680H - Primary; Secondary Configuration

38
B680H 55 732719 - Rev.E
DL2
DL2
2EASY
3 4 5 6 7 8 9
11
10
12 13 14 15 16 17 18 19 2120 24 25 26 27
F+ -
M.A.
CAL1 CAL2
2EASY
3 4 5 6 7 8 9
11
10
12 13 14 15 16 17 18 19 2120 24 25 26 27
F+ -
S.L.
CAL1 CAL2
Translation of the original instructions
ENGLISH
PRIMARY / SECONDARY CONFIGURATION
1. Switch power on to the barriers.
2. On both boards, carry out programming according
to the beam configuration and length (
cF in Basic
Programming).
3. Set:
-
Ct=MA on the primary board
-
Ct=SL on the secondary board
i
The operating logic should only be programmed on the
Primary board.
4. Check the status of the LEDs on the boards and
make sure that LED DL2 (green) is lit.
5. Check the driving direction for both barriers (see
§ 5.4).
6. Bring the automations to the fully closed position
using parameter Mt in BASIC programming.
7. Access Basic programming on the Primary board
and select parameter
tL, then press the ++ and
--
buttons at the same time until both automation
systems start to open slowly. The
-- symbol
flashes on the display
.
8. On reaching the fully open position, both automa-
tion systems will stop automatically.
9. The automation systems will then begin the beam
closing movement.
10. On reaching the closed position, the movement
will stop automatically.
11. Press the F button to exit the procedure and
confirm that you wish to save the data using
parameter
St.
12. Check that the current status of the automation
shown on the display of both automation systems
is
00 (closed) and that the beam is in the closed
position.
i
During setup the Primary board controls the Second-
ary board.
When a device is configured as Secondary, the unused
parameters will be hidden in the programming menus.
B680H Primary B680H Secondary