FAAC B680H - Firmware Version; Automation Status

B680H 58 732719 - Rev.E
Translation of the original instructions
ENGLISH
9.2 FIRMWARE VERSION
When the display of the E680S is switched on, it shows
the following in succession:
- firmware version (2 digits separated by a point)
- automation system status
9.3 AUTOMATION STATUS
The E680S display if not in the programming, shows a
code indicating the status the automation is in:
00
Closed
01
Open
02
Stationary then opens
03
Stationary then closes
04
In pause mode
05
Opening
06
Closing
07
Failsafe in progress
08
BUS 2easy device verification in progress
09
Pre-flashing and then opens
10
Pre-flashing and then closes
11
Opening in Emergency