FAAC B680H - Diagnostics and Troubleshooting

B680H 57 732719 - Rev.E
SW1 SW2 SW3
MOTOR
2EASY
3 4 5 6 7 8 9
11
10
12 13 14 15 16 17 18 19 2120 24 25 26 27
8.8.
RP/DECODER
CAL1 CAL2
DL8
DL2
DL6
DL5
DL9
DL14
DL4
DL16
DL18
DL10
DL11 DL13
DL12
DL3
DL1
DL17
DL7
DL15
40
Translation of the original instructions
ENGLISH
9. DIAGNOSTICS
9.1 DISPLAY SIGNALS
The items in bold in table  11 indicate the condi-
tion of the LEDs with the board powered and the
beam closed.
 11 LED diagnostics
LED
Colour
Meaning
 
 
DL1 red BUS 2easy operation
see § Devices BUS 2easy, § Opposing barriers
DL2 green BUS 2easy line diagnostics
DL3 red LOOP1 status Engaged Idle - -
DL4 red LOOP2 status Engaged Idle - -
DL5 red Board faulty signal Errors/alarms pre-
sent
No errors/alarms - -
DL6 red Not used - - - -
DL7 red Encoder Status - Stopped Moving (the flashing frequency is
related to the speed)
DL8 red Not used - - - -
DL9 green Board powered Power on No power - -
DL10 red Input status LED OPEN Active not active - -
DL11 red Input status LED CLOSE Active not active - -
DL12 red Input status LED FSW Not active Active - -
DL13 red Input status LED STOP Not active Active - -
DL14 red Input status LED EMR Not active Active - -
DL15 red Beam released signal Beam not
released
Beam released - -
DL16 red Battery operation signal Battery in
operation
Battery not in
operation
- -
DL17 red Radio channel 1 activity Receiving
command
Idle - -
DL18 red Radio channel 2 activity Receiving
command
Idle - -
=on =off
=slow flashing =fast flashing
i
In Primary-Secondary configuration see § 8.1.