FAAC B680H - Installing Modular Beams (Optional); Completing the Beam Installation

20
B680H 20 732719 - Rev.E
19
C
C
C
D1
D2
E
B
A
Translation of the original instructions
ENGLISH
INSTALLING MODULAR BEAMS OPTIONAL
With reference to 19:
1. Connect joint A to joint B.
i
Joint B has holes on both sides and must be positioned
as shown in 19.
2. Insert the joints into the beam and insert the fixing
screws, but without tightening them.
3. Install the extension onto the joints and insert
the screws.
4. Tighten the screws.
COMPLETING THE BEAM INSTALLATION
With reference to 20:
1. Apply the adhesive reflectors C to both sides of
the beam.
2. Insert the optional profiles D1 and D2 by sliding
them onto the beam.
i
The rubber profile (D2) must face the closing direction.
3. Place the cover E over the end of the beam and fix
it in place with the screws.