FAAC B680H - Topping up the Oil; Periodic Replacements

B680H 62 732719 - Rev.E
41
A
MAX
MIN
A
Translation of the original instructions
ENGLISH
 14 Periodic replacements
Component Frequency in work cycles
Control unit 2000000
Plunger pistons 2000000
10.2 TOPPING UP THE OIL
Operations Frequency/months
Check oil level 6
Bleed the air If necessary
To top up the oil, follow the procedure below:
1. Unscrew the oil filler cap A and remove it.
2. Check the oil level: the oil level must be between
the two marks.
3. If necessary, top up the oil without exceeding the
maximum level.
4. Replace the cap and tighten it.
i
Only use oil supplied by FAAC for topping up.