B680H 61 732719 - Rev.E
Translation of the original instructions
ENGLISH
Operations Frequency/months
Deformable edges
Check that they are intact and correctly fastened. 12
Photocells
Check condition, fastening and correct operation. 6
Check the posts, ensuring that they are intact, correctly fastened and free of deformation etc. 6
Flashing light
Check condition, fastening and correct operation. 12
Access control
Check the proper opening of the barrier only with authorised user recognition. 12
Hedge
Check: the integrity and fixing of the beam. 6
Foot
Check: the integrity and fixing of the beam. 6
Check the presence and integrity of the reflectors on the foot and all the other signs and markings
necessary.
6
Check the presence and integrity of the lower foot guard. 6
Fork
Check that they are intact and correctly fastened. 6
Check the presence and integrity of all the signs and markings necessary. 6
Jointed beam
Check that they are intact and correctly fastened. 6
Check the integrity of the wire and the relative signs (max height allowed, risk of crushing in the beam
joint).
6
Check the LED lights 5 years
Complete automation system
Check the correct functioning of the manual release: when the release is activated it must only be possible
to move the beam manually.
Check the presence of the lock cover.
6
Check that the maximum force required to move the beam by hand is less than 220 N. 6
Check that the encoder is working properly. 6
Check the force limitation curve (standards EN 12453 and EN 12445). For non-EU countries, of there are
no specific local regulations, the force must be less than 150 N.
6
Check that the automation operates correctly, following the set logic, when using the various control
devices.
12
Check the proper fluid, smooth movement of the beam without strange noises.
Check the correct speed during opening and closing and the respect for the intended slow downs.
12
Check that all necessary signage and warnings are present, intact and legible: residual risks, exclusive
use etc.
12
Check the presence, integrity, legibility of the EC marking covering the automation system and the DANGER
AUTOMATIC MOVEMENT warning sign
12
i
For non FAAC components, refer to the manufacturer's documentation.
To Next Page
Loading...
