FAAC B680H - Installing the Bracket and Beam

18
B680H 19 732719 - Rev.E
I
L
C
A
B
19
60 Nm
D
E
B
F
G
H
13
20 Nm

Translation of the original instructions
ENGLISH
3.4 INSTALL THE BRACKET AND BEAM
i
If the beam has to be shortened, cut the end opposite
the one with the fixing hole. After the cutting remove
any sharp borders and burs.
1. Insert the spacer A and screw the guide B into the
drive shaft on the barrier body.
2. Insert the plate C so that it rests on the spacer
A. Make sure that you insert the plate the cor-
rect way round.
3. Remove the guide B and put it to one side.
4. Fix in position with the screw D, interposing the
washers E.
i
Do not apply grease to the fastening screw D.
5. Insert the adapter F.
6. Insert the beam G.
7. Mount the bracket H and secure it using the screws
and washers (4 screws for the S beam and 6 for
the L beam).
8. Insert the cover I and secure it with the screws.
9. Fasten the plate L.
10. Move the beam to the closed position.
11. Restore the barrier lock.