Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·149·
General machine parameters
For the 8055i CNC model.
About the handwheels:
Depending on their configuration, the available handwheels are:
• General handwheel.
It can be used to jog any axis one by one. Select the axis and turn the handwheel to move it.
• Individual handwheel.
It replaces the mechanical handwheels. Up to 3 handwheels can be used (one per axis). It only
moves the axis it is associated with.
When using a Fagor 100P handwheel, no other handwheels may be used and it must be connected
as first handwheel. See "7.3 Movement with an electronic handwheel" on page 309.
INCHES (P8)
It defines the measuring units assumed by the CNC for machine parameters, tool tables and
programming on power-up and after executing M02,M30, EMERGENCY or RESET. The code is:
IMOVE (P9)
Indicates which function G00 (rapid traverse) or G01 (linear interpolation) is assumed on power-
up, after executing M02,M30, EMERGENCY or RESET. The code is:
ICORNER (P10)
Indicates which function, G05 (round corner) or G07 (square corner) is assumed on power-up, after
executing M02,M30, EMERGENCY or RESET. The code is:
Parameter Feedback Command Default value
(connector) - M - - T -
AXIS1 (P0) 1st axis X10 X8 - Pin 2 1 (X axis) 1 (X axis)
AXIS2 (P1) 2nd axis X11 X8 - Pin 3 2 (Y axis) 3 (Z axis)
AXIS3 (P2) 3rd axis X12 X8 - Pin 4 3 (Z axis) 0 (free)
AXIS4 (P3) 4th axis X13 X8 - Pin 5 4 (U axis) 0 (free)
AXIS5 (P4) Spindle X4 X4 - Pins 10 and
12
10 (spindle) 10 (spindle)
AXIS6 (P5) 1st handwheel X5 ---- 11 (handwheel) 11 (handwheel)
AXIS7 (P6) 2nd handwheel X5 ---- 0 (free) 0 (free)
AXIS8 (P7) Not used ---- ---- 0 (free) 0 (free)
Value Meaning
0 Millimeters (G71)
1 Inches (G70)
By default: 0
Value Meaning
0 G00 (rapid traverse).
1 G01 (linear interpolation).
Default value: 0
Value Meaning
0 G07 (square corner).
1 G05 (round corner).
Default value: 0
To Next Page
Loading...
