Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·151·
General machine parameters
on the jog keypad; on vertical lathes, the X axis keys are swapped with those of the Z axis and vice
versa.
On M, MC, and MCO models, this parameter indicates the axis system being used for the graphic
representation as well as the motion possibilities for the W axis added to those of the Z axis in the
graphic representation (W additive).
RAPIDOVR (P17)
Indicates whether it is possible to vary the feedrate override between 0% and 100% when working
in G00.
The feedrate override % may be changed from the operator panel switch, from the PLC, via DNC
or by program.
The feedrate % can always be changed in JOG movements.
Possible values
Integer numbers between 0, 1, 2, 3.
Default value: 0
Value Meaning
0 Mill graphics.
1 Mill graphics with added W axis.
2 Boring Mill graphics.
3 Boring Mill graphics with added W axis.
4 Mill graphics (changed line graphics).
Default value: 0
GRAPHICS = 0 GRAPHICS = 1 GRAPHICS = 2
GRAPHICS = 3
GRAPHICS = 0 GRAPHICS = 4
Value Meaning
YES It may be modified.
EZ It cannot be modified; it is set to 100 %.
Default value: EZ
To Next Page
Loading...
