·166·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
Keyboard auto-identification
Certain keyboard models have a auto-identification system. With this type of keyboards, this
parameter is updated automatically; for the rest of the keyboards, this parameter must be set
manually.
If the keyboard does not match the CNC model, it shows the relevant error message and it loads
the key codes that correspond to the CNC model. For example, if a mill model keyboard is connected
to a lathe CNC, the keyboard is set for a lathe and the CNC shows the error message.
Possible configuration at an 8055 CNC.
To Next Page
Loading...
