Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·185·
General machine parameters
Bit 14:
Bit 14 activates the axis filters for movements with the handwheel. These filters will be activated only
during general or individual movements with the handwheel.
These filters are specifically for smoother movements with the handwheel. While acting only during
the handwheel movements, it ensures that they do not affect the remainder of the machine
movements.
The frequency of these filters is indicated by the machine axis parameter HANFREQ (P104).
If the bit 14 is programmed with a 0 value, the filters defined by the axis machine parameters ORDER
(P70), TYPE (P71) and FREQUEN (P72) for each axis.
Bits 0, 1, 2 and 3:
bits 0, 1, 2 and 3 indicate whether the handwheels output differential signals (1) or not (0).
RAPIDEN (P130)
It indicates how the rapid movements are carried out. The behavior of this key is managed using
the EXRAPID mark.
The rapid key is treated in execution and simulation as follows:
• The movements are carried out in rapid traverse (G00) while the rapid key is pressed.
• The rapid key is ignored while threading, while look-ahead is active.
• If G95 is active, it switches to G94 mode. When releasing the rapid key, it goes back to G95 mode.
• It only affects the main channel. It is ignored in the PLC channel.
MSGFILE (P131)
Number of the program that contains the OEM texts in several languages.
By default, the CNC sets this parameter to "0" (there is no program).
If programmed with a value of "0", the texts defined by the OEM are in a single language and stored
in several programs:
PLCMSG Texts for PLC messages.
PLCERR Texts for PLC errors.
P999995 Texts and titles used by all the OEM screens.
P999994 Help texts of the OEM screens or cycles.
The MSGFILE program may be in user memory or in the hard disk (KeyCF). If it is in several places,
it takes the one in user memory.
FLWEDIFA (P132)
Not used.
The axis filters for handwheel movements are not activated when the path handwheel mode is
activated, or in additive handwheel movements.
Value Meaning
0 It has no effect.
1 When the mark is activated or the "rapid" key is pressed, the movements are executed
in rapid.
2 When the mark is activated and the "rapid" key is pressed, the movements are executed
in rapid.
Default value: 0
To Next Page
Loading...
