Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·187·
General machine parameters
AXIS9 (P136) PAXIS9 (P137) AXIS10 (P138)
PAXIS10 (P139) AXIS11 (P140) PAXIS11 (P141)
AXIS12 (P142) PAXIS12 (P143)
If a CNC is configured so that any of the feedback inputs of its axes or spindles is free (because
they are digital axes or spindle without feedback connection to the CNC), these free connectors
could be configured as electronic or mechanical handwheels.
AXIS9 ... AXIS12.
Define the handwheel type. The values to be assigned to these parameters are:
PAXIS9 ... PAXIS12.
Define which connector is each handwheel associated with. Values 1 through 8 must be assigned
to these parameters depending on the connector that the handwheel is associated with.
When detecting any incompatibility, on power-up, it will issue the messages "Feedback busy" or
"Feedback not available".
ACTBACKL (P144)
It is related to axis parameter BACKLASH (P14), leadscrew backlash compensation due to change
of direction.
This parameter has 16 bits counted from right to left.
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
Bit 13. Backlash compensation on arcs G2/G3.
This bit indicates whether the compensation is applied only on circular paths G2/G3 (bit=1) or in
any other type of movement (bit=0).
Value Meaning Value Meaning
11 Handwheel. 12 Handwheel with axis selector button
21 Handwheel associated with X. 22 Handwheel associated with Y.
23 Handwheel associated with Z. 24 Handwheel associated with U.
25 Handwheel associated with V. 26 Handwheel associated with W.
27 Handwheel associated with A. 28 Handwheel associated with B.
29 Handwheel associated with C.
Bit Meaning Bit Meaning
0 8
1 9
2 10
3 11
4 12
5 13 G2 / G3
6 14
7 15
Default value in all the bits: 0
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
