Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·195·
General machine parameters
With "CAXGAIN (P163) = 1" and high values of both gains, the machine could be jerky depending
on the type of certain parts. When that happens, we recommend to select a gain set with very small
values or zero.
TOOLMATY (P164)
When using a non-random tool magazine (e.g. a turret), it indicates how many tools may be assigned
to each turret position.
When defined with a ·0· value in a non-random magazine, the tools must be placed in the tool
magazine table in the pre-established order (P1 T1, P2 T2, P3 T3, etc.).
MAXOFFI (P165)
Tool wear offsets may be modified from tool inspection mode. This parameter indicates the
maximum amount of wear that may be entered for "I" (it is programmed in mm or in inches).. It is
defined in diameter at the lathe model.
Default value: 0.5
MAXOFFK (P166)
Tool wear offsets may be modified from tool inspection mode. This parameter indicates the
maximum amount of wear that may be entered for "K" (it is programmed in mm or in inches)..
Default value: 0.5
TOOLTYPE (P167)
It defines the behavior of the tool or of the tool offset.
This parameter has 16 bits counted from right to left.
Each bit has a function or work mode associated with it. By default, all the bits will be assigned the
value of ·0·. Assigning the value of ·1· activates the corresponding function.
Bit 12. Enables/disables anticipated tool management.
This functionality is used to optimize the time required to change tools on machines that have a tool
magazine with a tool changer arm. This optimization consists in preparing the magazine while
machining to pick up the tool that will be used in the next operation.
Bit 13. The stop signal is taken into account after the "T" function is completed.
This function is applied when the tool change subroutine has been defined so it is executed as a
single block and the stop signal has been disabled.
Value Meaning
0 One tool per position. (P1 T1, P2 T2, etc.).
1 The tool can occupy any position.
Default value: 0
Bit Meaning
0 - 11 Not used.
12 Enables/disables anticipated tool management.
13 The STOP signal is always executed after the "T" function.
14 Machining in round corner mode when changing the tool offset.
15 Stop block preparation when executing a new "T".
Default value in all the bits: 0
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
