Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·199·
General machine parameters
OFFANGAX (P174)
Distance between machine zero and the origin of the coordinate system of the incline axis.
COMPMODE (P175)
It defines how to apply tool radios compensation.
COMPMODE = 0.
The compensation method depends on the angle between paths.
• For angles up to 300º, it compensates joining both paths with straight sections.
• For angles over 300º, it compensates joining both paths with arcs.
COMPMODE = 2.
The compensation method depends on the angle between paths.
• For angles up to 300º, it calculates the intersection between the compensated paths.
• For angles over 300º, it resolves it like when COMPMODE = 0.
ADIMPG (P176)
This parameter enables manual intervention with an additive handwheel.
This function allows jogging the axes while a program is being executed. This movement will be
applied as if it were another zero offset.
This parameter has 16 bits counted from right to left.
Possible values
Within ± 99999.9999 millimeters.
Within ±3937.00787 inches.
Default value: 0
Value Meaning
0 With an angle between paths of up to 300º, both paths are joined with straight sections.
In the rest of the cases, both paths are joined with arcs.
1 Both paths are joined with arcs.
2 With an angle between paths of up 300º, it calculates the intersection. In the rest of the
cases such as COMPMODE = 0.
Default value: 0
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
