·202·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
General machine parameters
ISOSIMUL (P183)
In the conversational mode of the CNC, it is possible to generate an ISO-coded program with some
basic G functions as well as M and T functions from an operation (cycle) or on a part-program.
This parameter identifies the number of the ISO program generated in user RAM memory.
DISSIMUL (P184)
It may be used to disable the simulation modes and the block search modes when selecting blocks
in execution. Setting the relevant bit to 1 disables it and removes from the menu the softkey assigned
to this bit.
This parameter has 16 bits counted from right to left.
For the block search: Disabling in execution:
For simulation: Disabling in simulation:
Value Meaning
0 An ISO-coded program cannot be generated.
1 - 65535 Indicates the number of the ISO-coded program generated.
Default value: 0
DISSIMUL = x x x x x x x x 0/1 x x x x x x x
bit 7 = 1 EXEC G SEARCH
bit 6 = 1 EXEC GMST SEARCH
DISSIMUL = 0/1 x x x x x x x x x x x x x x x
bit 10 = 1 RAPID [S0]
bit 11 = 1 RAPID
bit 12 = 1 MAIN PLANE
bit 13 = 1 G, M, S, T FUNCTIONS
bit 14 = 1 G FUNCTIONS
bit 15 = 1 THEORETICAL PATH
bit
15
14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
To Next Page
Loading...
