·218·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Axis parameters
MAXVOLT (P37)
Defines the value of the velocity command corresponding to the maximum feedrate of the axis
indicated by axis parameter G00FEED (P38).
G00FEED (P38)
Indicates the maximum feedrate G00 (rapid traverse) of this axis.
UNIDIR (P39)
Indicates the direction of the unidirectional approach in G00 moves.
OVERRUN (P40)
Indicates the distance to be kept between the approach point and the programmed point. If it is a
Lathe model, this distance must be in radius.
UNIFEED (P41)
Indicates the feedrate to be used from the approach point to the programmed point.
MAXFEED (P42)
Indicates the maximum programmable feedrate (F0).
Possible values
Integer numbers between 0 mV and 9999 mV.
Default value: 9500 (9.5 V)
Possible values
Between 0.0001 and 199999.9999 degrees/min or mm/min.
Between 0.00001 and 7874.01574 inches/min.
Default value: 10000 mm/min.
Value Meaning
+ sign Positive direction.
- sign Negative direction.
Default value: + sign
Possible values
Between 0.0001 and 99999.9999 degrees/min or mm/min.
Between 0.00001 inches/min and 3937.00787 inches/min.
Default value: 0 (not unidirectional)
Possible values
Between 0.0001 and 99999.9999 degrees/min or mm/min.
Between 0.00001 inches/min and 3937.00787 inches/min.
Default value: 0
Possible values
Between 0.0001 and 199999.9999 degrees/min or mm/min.
Between 0.00001 and 7874.01574 inches/min.
Default value: 5000 mm/min.
To Next Page
Loading...
