·220·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Axis parameters
REFSHIFT (P47)
This parameter is used when once the machine has been all set up, it is necessary to reinstall the
feedback system and the new machine reference point (home) no longer coincides physically with
the previous one.
It indicates the difference existing between the two reference points, the previous one and the current
one.
If this parameter has a value other than 0, once the home search has been carried out (the reference
mark of the feedback device has been detected) , the CNC moves the distance indicated by axis
parameter REFSHIFT (P47). This way, the machine reference point will always be the same.
This movement is carried out at the feedrate indicated by axis parameter REFEED2 (P35).
STOPTIME (P48) STOPMOVE (P49)
These parameters are used in conjunction with axis parameter "STOPAOUT (P50)" with function
G52 (move to hardstop).
STOPTIME (P48).
The CNC considers that the hardstop has been run into when a certain time period elapses without
the axis moving. This time period is indicated, in thousands of a second, by parameter STOPTIME
(P48).
STOPMOVE (P49).
The CNC considers the axis to be stopped when its movements do not exceed the value set by
STOPMOVE (P49) during the time period set by STOPTIME (P48).
ACFGAIN = NO
ACFGAIN = YES
Possible values
Within ±838.8608 degrees or millimeters.
Within ±33.026 inches.
Default value: 0
Possible values
Integers between 0 and 65535 ms.
Default value: 0
Possible values
Between 0.0001 and 99999.9999 millimeters.
Between 0.00001 and 3937.00787 inches.
Default value: 0
To Next Page
Loading...
