·232·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Axis parameters
FLIMIT (P75)
Maximum safety limit for the axis feedrate. This limit is activated from the PLC and is applied to all
the work modes, including the PLC channel.
This limit is activated for all the axes using the mark FLIMITAC (M5058). When the limit is canceled,
the CNC recovers the programmed feedrate.
This limit permits clearing the axis feedrate temporarily via PLC, e.g. when opening the doors, etc.
In the following cases, the value set in axis parameter FLIMIT (P75) is not exceeded:
1. Electronic handwheel:
In order to respect the limit set by axis parameter FLIMIT(P75), some of the pulses received
from the handwheel must be ignored when exceeding FLIMIT; i.e. if FLIMIT is active, some
pulses will be lost whether bit 15 of general parameter HDIFFBAC (P129) is set to 0 or to 1.
2. Handwheel associated with a mechanical handwheel.
3. Path-handwheel.
TANSLAID (P76)
Sercos identifier ID of the slave axis of the Tandem axis. This parameter of the master axis selects
the axis that will generate the velocity command for the slave axis.
This parameter enables all the other parameters of the Tandem axis. If this parameter is zero, there
is no Tandem axis and it ignores the rest of the Tandem control parameters. All the parameters of
the Tandem axis are set in the parameter table of the master axis.
TANSLANA (P77)
Slave axis of the tandem axis. The axis whose table sets the parameters will be the master axis of
the Tandem axis.
Calculation example for a particular response of the machine.
Possible values
Between 0 and 99999.9999 degrees/min or mm/min.
Between 0 inches/min and 3937.00787 inches/min.
Default value: 0
Value Meaning Value Meaning
0 None. 5V axis.
1X axis. 6W axis.
2Y axis. 7A axis.
3Z axis. 8B axis.
4U axis. 9C axis.
Default value: 0 (none)
To Next Page
Loading...
