·238·
Installation manual
CNC 8055
CNC 8055i
6.
MACHINE PARAMETERS
SOFT: V02.2X
Axis parameters
additional velocity command is eliminated (peak compensation cutoff) depending on the values of
the following parameters:
General parameter BAKTIME (P30), general parameter ACTBAKAN (P145) and axis parameter
PEAKDISP (P98).
The axis machine parameter PEAKDISP (P98) defines the actual distance traveled along the
corresponding axis after the theoretical reversal, from which the reversal peak is cut off on that axis.
This axis machine parameter will be taken into account when bit 1 of general machine parameter
ACTBAKAN (P145) is set to ·1· if the peak is exponential or if it is square.
If the value of axis parameter PEAKDISP (P98) = 0 and bit 1 of general parameter ACTBAKAN
(P145) = 1, the compensation peak will be cut off with the second consecutive loop where the
counting reversal has been detected.
Example:
Cutting the exponential compensation off.
Possible values
Between 0 and 99999.9999 millimeters.
Default value: 0,005
[rpm]
Command to end the execution
of the compensation (cutoff).
The axis has moved
PEAKDISK mm indicated by
the feedback device.
Command to execute
the compensation.
[ms]
Theoretic
al
Moving distance
set by parameter (PEAKDISP).
Position given
by the feedback
device.
To Next Page
Loading...
