Installation manual
CNC 8055
CNC 8055i
MACHINE PARAMETERS
6.
SOFT: V02.2X
·251·
Spindle parameters
M19TYPE (P43)
This parameter sets the type of spindle orient (M19) available.
It indicates whether the spindle must be homed when switching from open to closed loop or it is
enough to home it once on power-up.
DRIBUSID (P44)
It indicates the address of the digital drive (Sercos or CAN) associated with the spindle. It
corresponds with the value of the drive's rotary switch (address, device select).
It is recommended (not necessary) that the Can addresses of the various axes and spindles be
consecutive and start from number ·1· (the address of the CNC is always ·0·). For example, with
3 Sercos axes and 1 Sercos spindle, the values of this parameter must be 1, 2, 3 and 4. Proceed
in the same way if it is a CAN connection.
OPLACETI (P45)
When working in open loop (M3, M4) spindle command variations may be in a step or in a ramp.
This parameter indicates the duration of the ramp in milliseconds for the maximum "S". If
OPLACETI=0, it will be in a step.
ACFGAIN = NO
ACFGAIN = YES
Value Meaning
0 When switching from open loop to closed loop.
1 Once after power-up.
Default value: 0
Value Meaning
0 Analog spindle.
1 - 8 Address of the digital drive.
Default value: 0
Possible values
Integers between 0 and 65535 ms.
Default value: 0 (in steps).
To Next Page
Loading...
