Installation manual
CNC 8055
CNC 8055i
CONCEPTS
7.
SOFT: V02.2X
·383·
Configuring a CNC as two and a half axes
7.17.1 Machine parameter setting
The following machine parameters must be modified to configure the CNC as having two and a half
axes:
CODISET (P147)
This parameter has 16 bits counted from right to left. Bit ·2· indicates whether the CNC is configured
as two and a half axes (bit=1) or not (bit=0).
COCYF1 (P148) COCYF5 (P152) COCYZ (P155)
These parameters allow hiding operations or cycles that are not used showing only the desired ones.
Each parameter is associated with an operation or cycle and each one of their bits refers to each
available level.
Each parameter has 16 bits counted from right to left. By default, all the bits will be assigned the
value of ·0· (option available). Assigning the value of ·1· hides the level of the corresponding cycle.
COCYZ (P155) 0000 0000 0100 0110
COCYF5 (P152) 0000 0000 0000 0010
COCYF1 (P148) 0000 0000 0000 0010
The PROBE1 cycle can also be hidden by setting parameters "PRBXMIN (P40)" through
"PRBZMAX (P45)" to zero.
Bit Meaning
6 It hides the threading cycle.
2 It hides the drilling 3 cycle.
1 It hides the drilling 2 cycle.
Bit Meaning
1 It hides the 3D profile pocket cycle.
Bit Meaning
1 It hides the PROBE 1 cycle.
To Next Page
Loading...
