·84·
Installation manual
CNC 8055
CNC 8055i
2.
CNC 8055 I CONFIGURATION
SOFT: V02.2X
CNC structure
Connector X5 - For electronic handwheel connection
15-pin high density SUB-D type female connector.
It admits differential (double-ended) and non-differential (single-ended) TTL feedback.
The cable must have overall shielding. The rest of the specifications depend on the feedback system
used and the cable length required.
The cable shield must be connected to the metallic hood at each end.
It is highly recommended to run these cables as far as possible from the power cables of the machine.
When using a FAGOR 100P model handwheel, connect it as first handwheel and connect the axis
selecting signal (button) to pin 13.
Pin Signal and function
1
2
3
4
A1
/A1
B1
/B1
Feedback signals of first handwheel.
5
6
7
8
A2
/A2
B2
/B2
Feedback signals of second handwheel.
9
10
11
12
13
14
15
+5 V
+5 V
11
11
100P
- - -
Chassis
Supply output.
Supply output.
Supply output.
Supply output.
Push button of Fagor 100P handwheel.
Shield
To Next Page
Loading...
