Installation manual
CNC 8055
CNC 8055i
CNC 8055 I CONFIGURATION
2.
SOFT: V02.2X
·97·
CNC structure
Characteristics of the CAN cable.
Use a specific CAN cable. The ends of all the wires and the shield must be protected by the
corresponding terminal (pin). Also use the terminals (pins) to secure the cable to the connector.
Type: Shielded. Twisted pairs (1 x 2 x 0,22 mm
2
).
Flexibility: Extremely flexible. Minimum bending radius, static = 50 mm and dynamic
= 95 mm.
Cover: PUR.
Impedance: Cat.5 (100 - 120 ).
Interconnection of modules.
It is a serial connection and any of the two connectors may be used. The figure shows the CAN
connection between the central unit and 2 groups of remote modules.
To Next Page
Loading...
