Fagor CNC 8055i FL EN - Page 99

Installation manual
CNC 8055
CNC 8055i
CNC 8055 I CONFIGURATION
2.
SOFT: V02.2X
·99·
CNC structure
CAN connector pinout.
5-pin male Phoenix minicombicon connector (3.5 mm pitch).
The connector has two shield pins. Both pins are equivalent; the CAN shield may be connected to
either one.
Interconnection of modules.
It is connected in series. The figure shows the CAN connection between the central unit and 2 drives.
Signal Description
ISO GND Ground / 0 V.
CAN L (LOW) bus signal.
SHIELD CAN shield.
CAN H (HIGH) bus signal.
SHIELD CAN shield.
CAN L
SHIELD
CAN H
SHIELD
ISO GND
1
2
3
4
5
1
2
3
4
5
Pin Pin