Fagor CNC 8060 - Page 111

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·111·
Machine parameters for the axes and spindles.
SREVM05
With G84, the spindle must be stopped to change the turning
direction.
Parameter valid for spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.SREVM05.xn
This parameter indicates whether the spindle must be stopped (with M5) when reversing the
spindle in tapping cycle.
M19SPDLEREV
The SPDLEREV mark (reverse turning direction) affects the
spindle in M19.
Parameter valid for spindles.
Parameter valid for an analog drive.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)[ch].MPA.M19SPDLEREV.xn
This parameter defines whether the PLC mark SPDLEREV (reverse turning direction) also
affects the spindles in M19. The SPDLEREV mark always affects the spindles in open loop
(M3/M4), regardless of how this parameter has been set.
STEPOVR
Spindle override step.
Parameter valid for spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 255.
Default value: 5.
Associated variable: (V.)[ch].MPA.STEPOVR.xn
This parameter sets the incremental step used to change the programmed spindle speed
with the spindle override keys of the operator panel. Parameter ignored when the operator
panel has a spindle speed override switch.
MINOVR
Minimum override (%) permitted for the spindle.
Parameter valid for spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 255.
Default value: 50.
Associated variable: (V.)[ch].MPA.MINOVR.xn
This parameter sets the minimum percentage allowed to apply to the spindle speed when
it is changed from the operator panel (keys or speed override switch).
MAXOVR
Maximum override (%) permitted for the spindle.
Parameter valid for spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 255.
Default value: 150.
Associated variable: (V.)[ch].MPA.MAXOVR.xn
This parameter sets the maximum percentage allowed to apply to the spindle speed when
it is changed from the operator panel (keys or speed override switch).