·206·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the magazine.
2.10.1 Types of tool magazine.
The CNC can manage the following types of magazine:
Turret type .
It is a typical magazine for lathes. The tool cannot be changed while the part is being
machined.
Synchronous magazine without changer arm.
In a synchronous tool changer without arm, the magazine must move up to the spindle to
change the tool. The tool cannot be changed while the part is being machined.
The tool change is carried out as follows:
1 It ends the movement of the axes.
2 The magazine approaches the spindle to grab the tool.
3 It selects the new tool and puts it in the spindle.
4 The magazine retracts.
5 The CNC resumes program execution.
Asynchronous magazines with changer arm (1 or 2 claws).
Synchronous magazines with tool changer arm (1 or 2 holders) have the magazine close
to the spindle. The tool cannot be changed while machining the part because the arm would
collide.
A Turret.
B Synchronous without changer arm.
C Synchronous with an arm with 1 claw (or 2 claws).
D Asynchronous.
To Next Page
Loading...
