·388·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Synchronous magazine with changer arm and 1 claw
7.9.4 Program of the M06 subroutine.
%L SUB_MZ_TO_CH1
Take the tool from the magazine with holder 1.
M101
Auxiliary function to execute an action.
V.PLC.M[1101]=1
MZTOCH1 mark to the tool manager.
#RET
%L SUB_CH1_TO_SPD
Take the tool of holder 1 to the spindle.
M102
Auxiliary function to execute an action.
V.PLC.M[1102]=1
CH1TOSPDL mark to the tool manager.
#RET
%L SUB_SPD_TO_CH1
Take the spindle tool with holder 1.
M103
Auxiliary function to execute an action.
V.PLC.M[1103]=1
SPDLTOCH1 mark to the tool manager.
#RET
%L SUB_CH1_TO_MZ
Take the tool of holder 1 to the magazine.
M105
Auxiliary function to execute an action.
V.PLC.M[1105]=1
CH1TOMZ mark to the tool manager.
#RET
%L SUB_SPD_TO_GR
Remove the tool from the spindle (take it to ground).
It shows the message for the operator to extract the tool and waits for the operation to
be completed before removing the message.
#MSG ["Extract tool T%D and press START", V.TM.TOOL]
M0
#MSG [""]
V.PLC.M[1107]=1
SPDLTOGR mark to the tool manager.
#RET
To Next Page
Loading...
