Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·731·
PLC modifiable logic signals; tool manager.
10.24 PLC modifiable logic signals; tool manager.
(V.)PLC.SETTMEM
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to activate the emergency of the tool manager.
(V.)PLC.RESTMEM
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to cancel the emergency of the tool manager.
(V.)PLC.CUTTINGON
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to indicate that the tool is machining (cutting).
(V.)PLC.TREJECT
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to reject the tool.
V.PLC.SETTMEM Magazine ·1·.
V.PLC.SETTMEMZ1 Magazine ·1·.
V.PLC.SETTMEMZ2 Magazine ·2·.
V.PLC.SETTMEMZ3 Magazine ·3·.
V.PLC.SETTMEMZ4 Magazine ·4·.
V.PLC.RESTMEM Magazine ·1·.
V.PLC.RESTMEMZ1 Magazine ·1·.
V.PLC.RESTMEMZ2 Magazine ·2·.
V.PLC.RESTMEMZ3 Magazine ·3·.
V.PLC.RESTMEMZ4 Magazine ·4·.
V.PLC.CUTTINGON Channel ·1·.
V.PLC.CUTTINGON1 Channel ·1·.
V.PLC.CUTTINGON2 Channel ·2·.
V.PLC.CUTTINGON3 Channel ·3·.
V.PLC.CUTTINGON4 Channel ·4·.
V.PLC.TREJECT Channel ·1·.
V.PLC.TREJECTC1 Channel ·1·.
V.PLC.TREJECTC2 Channel ·2·.
V.PLC.TREJECTC3 Channel ·3·.
V.PLC.TREJECTC4 Channel ·4·.
To Next Page
Loading...
