Fagor CNC 8060 - PLC Consulting Logic Signals; Spindles

·706·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; spindles.
10.16 PLC consulting logic signals; spindles.
(V.)PLC.REVOK
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The spindle turns this mark on when it reaches the programmed rpm.
The mark is also on when the spindle is stopped (M05) or in position (M19, G63).
(V.)PLC.SYNCMASTER
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The master spindle activates this mark when it has a spindle synchronized using #SYNC.
(V.)PLC.SYNCHRON
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The slave spindle activates this mark at the beginning of a synchronization using #SYNC.
(V.)PLC.SYNCHRONP
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The slave spindle activates this mark at the beginning of a synchronization in position.
V.PLC.REVOK Spindle ·1·.
V.PLC.REVOK1 Spindle ·1·.
V.PLC.REVOK2 Spindle ·2·.
V.PLC.REVOK3 Spindle ·3·.
V.PLC.REVOK4 Spindle ·4·.
V.PLC.SYNCHRON1 Spindle ·1·.
V.PLC.SYNCHRON2 Spindle ·2·.
V.PLC.SYNCHRON3 Spindle ·3·.
V.PLC.SYNCHRON4 Spindle ·4·.
V.PLC.SYNCHRON1 Spindle ·1·.
V.PLC.SYNCHRON2 Spindle ·2·.
V.PLC.SYNCHRON3 Spindle ·3·.
V.PLC.SYNCHRON4 Spindle ·4·.
V.PLC.SYNCHRONP1 Spindle ·1·.
V.PLC.SYNCHRONP2 Spindle ·2·.
V.PLC.SYNCHRONP3 Spindle ·3·.
V.PLC.SYNCHRONP4 Spindle ·4·.