Fagor CNC 8060 - Changing the Set and the Gear at the CNC and at the Drive

Installation manual
CNC 8060
CNC 8065
CONCEPTS.
9.
(REF: 1402)
·467·
Multi-axis management.
9.5.3 Changing the set and the gear at the CNC and at the drive.
A set is a bunch of parameters that may be activated and gear is a bunch of parameters
specifically related to gear ratios. The parameters that define the gear are included in the
set, one gear per set. A set change activates all its parameters, including those of the gear,
whereas a gear change only activates the specific gear-related parameters.
Axes and spindles included in a multi-axis group.
If the axis or spindle does not belong to a multi-axis group, functions G112 and M41 to M44
act in the same way at the CNC; but at the drive they activate the programmed gear, not the
one defined in parameter DRIVESET.
Spindle and C axis.
Function. CNC Drive.
G112
(axes only)
The CNC activates the programmed
set.
The drive activates the gear defined
in parameter DRIVESET of the
program set.
M41-M44
(spindles only)
The CNC activates the programmed
set.
The drive activates the gear defined
in parameter DRIVESET of the
program set.
(V.)A.SETGE.xn Not being used. The drive activates the programmed
set and/or gear.
Function. CNC Drive.
#CAX ON The CNC activates the set defined
in parameter CAXSET.
The drive activates the gear
defined in parameter CAXSET.
#CAX OFF The CNC restores the set that was
active before enabling the spindle
as C axis.
The drive restores the gear that
was active before enabling the
spindle as C axis.