·40·
Installation manual
CNC 8060
CNC 8065
1.
SOFTWARE INSTALLATION.
(REF: 1402)
Software configuration.
1.6.2 USERS folder.
This folder is especially directed at users. The purpose of this folder is to provide the user
with a memory space for storing part-programs, profiles, etc. as they are generated. We
recommend to save these programs in the folders created for this purpose in order to make
it easier and faster to find them and make safety backup copies.
Since the disk is write-protected, the programs created by the user must be saved in this
folder; the only one that is not protected. Any program saved in a protected folder will be
temporary and will be deleted when the CNC is turned off.
Folder. Contents.
HELP Each language of the ..\HELP folder contains the help files associated with
user-defined global subroutines and the pcall.txt file that contains the list of
user subroutines.
POCKET This folder contains the profiles that have been created using the profile
editor and are related to the editor cycles.
PRG This folder contains the part-programs created by the user who may create
new subfolders and store the programs in a more orderly fashion.
The subfolder "...\PRG_8055_TO_8070" contains the programs translated
from the 8055 format into the 8070 language. The CNC saves the converted
(translated) program with the same name but with the extension m55 (milling
program) or t55 (lathe program).
PROFILE This folder contains the profiles that have been created using the profile
editor.
REPORTS This folder contains the bmp files that the CNC generates when printing a
graphic to a file and the pm reports generated from the diagnosis mode.
SUB This folder contains the subroutines created by the user, whose location must
be fixed for the CNC (for example, the generic user subroutines G500-G599)
and the subroutine program_start)
To Next Page
Loading...
