Fagor CNC 8060 - Definition of the Table Kinetics (Types 9 through 12)

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·185·
Machine parameters for kinetics.
2.9.3 Definition of the table kinetics (Types 9 through 12).
The following types of rotary tables may be controlled.
TDATA2··TDATA5
Table dimensions.
The dimensions may be defined with a positive or negative value. The (+) sign in the
illustrations indicates that the direction is assumed as positive.
TDATA8
Rest position of the main rotary axis.
Possible values: Within ±99999.9999º.
Default value: 0.
See parameter TDATA9.
TDATA9
Rest position of the secondary rotary axis.
Possible values: Within ±99999.9999º.
Default value: 0.
The rest position is when the tool is perpendicular to the work plane (parallel to the
longitudinal axis).
TDATA10
Turning direction of the main rotary axis.
Possible values: 0 (by the standard DIN 66217) / 1 / opposite to the standard DIN 66217).
Default value: 0.
See parameter TDATA11.
TDATA11
Turning direction of the secondary rotary axis.
Possible values: 0 (by the standard DIN 66217) / 1 / opposite to the standard DIN 66217).
Default value: 1.
The direction of the XYZ axes, according to the DIN 66217 standard is easy to remember
using the rule of the right hand. On rotary axes, the turning direction is established when
bending your fingers (closing your hand) around the associated linear axis while your thumb
is pointing in the positive direction of the linear axis. On kinematics with rotary axes on the
table, the turning direction is set from the point of view of the tool; therefore, TDATA10 and
TDATA11 must be set to 1.
TDATA2 It indicates the position of the secondary rotary axis or the intersection with
the primary axis along the X axis.
TDATA3 It indicates the position of the secondary rotary axis or the intersection with
the primary axis along the Y axis.
TDATA4 It indicates the position of the secondary rotary axis or the intersection with
the primary axis along the Z axis.
TDATA5 It indicates the distance between the secondary and the main rotary tables.