·36·
Installation manual
CNC 8060
CNC 8065
1.
SOFTWARE INSTALLATION.
(REF: 1402)
Requirements before and after CNC setup.
1.4 Requirements before and after CNC setup.
The CNC setup is carried out in setup mode. Fagor delivers the unit ready to start up in this
mode. When powering the unit up, the desktop will show an image showing this
circumstance.
After starting the CNC application, proceed with setup. When starting the application, it will
display a warning indicating that it is operating in an unsafe mode.
When closing the application with the key sequence [ALT]+[F4] and choosing the options
to "close" or to "close and make a backup copy", the CNC shows a second dialog box asking
whether setup has been completed or not. If the "NO" is chosen, the next time the unit is
turned on, it will start in setup mode again. If the "Yes" option is chosen, the CNC makes a
backup copy of the MTB folder and, the next time it is turned on, the unit will start in user mode.
The unit will remain in setup mode until the manufacturer changes it to user mode in response
to the dialog displayed when shutting the application down. If while in user mode, it is
necessary to change something that has to do with setup, the setup mode must be accessed
manually. See "1.1.1 Work modes and software protection at the CNC." on page 29.
When starting the application up, either in setup or user mode, the CNC display can show
warnings whose cause must be solved by the manufacturer during setup.
The unit must be delivered to the user ready to start up in user mode.
To Next Page
Loading...
Need help?
General
