Fagor CNC 8060 - PLC Consulting Logic Signals; Independent Interpolator

·708·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; independent interpolator.
10.17 PLC consulting logic signals; independent interpolator.
(V.)PLC.IBUSYxn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The interpolator is active when there is an instruction pending execution.
Syntax.
·xn· Name or logic number of the axis.
(V.)PLC.IFREExn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The interpolator turns this mark on when it is ready to accept a motion block.
Syntax.
·xn· Name or logic number of the axis.
(V.)PLC.IFHOUTxn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The interpolator turns this mark on when the execution is interrupted.
Syntax.
·xn· Name or logic number of the axis.
(V.)PLC.IENDxn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The interpolator turns this mark on when the axis movement has finished and it has reached
its the final position.
Syntax.
·xn· Name or logic number of the axis.
V.PLC.IBUSYX X axis.
V.PLC.IBUSY3 Axis with logic number ·3·.
V.PLC.IFREEX X axis.
V.PLC.IFREE3 Axis with logic number ·3·.
V.PLC.IFH OUTX X axis.
V.PLC.IFH OUT3 Axis with logic number ·3·.
V.PLC.IENDX X axis.
V.PLC.IEND3 Axis with logic number ·3·.