Fagor CNC 8060 - Parameters to Verify before the Startup

Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·45·
Parameters to verify before the startup.
2.2 Parameters to verify before the startup.
Te ensure the proper performance of the CNC and prevent any damage to the machine, the
machine parameters must be properly set, especially the ones related to alarms, travel limits,
following errors, feedrate and speed. After the setup, make sure that the parameters related
to these aspects are set with operative values.
For safety reasons, verify that these parameters are properly set; wrong values, even if they
are within the permitted range could cause the machine to perform poorly.
Here are the parameters that you should at least check.
General machine parameters.
Machine parameters for the axes and spindles.
Parameter Meaning
WARNCOUPE Gantry axis. Maximum difference allowed between the following errors of
both axes before issuing a warning.
MAXCOUPE Gantry axis. Maximum difference allowed between the following errors of
both axes.
MINCORFEED Minimum feedrate for the HSC at the corners.
MAXFEED Maximum machining feedrate.
This parameter should be set to a value other than ·0·.
Parameter Meaning
FBACKDIFF Maximum difference between feedbacks. The CNC takes this parameter into
consideration the axes set as position Sercos and with external feedback or
external+internal feedback.
This parameter should be set to a value other than ·0·.
DSYNCVELW Synchronization of axes and spindles. This parameter is defined for the slave
element of the synchronization and indicates the velocity margin admitted
for the synchronization to be OK.
DSYNCPOSW Synchronization of axes and spindles. This parameter is defined for the slave
element of the synchronization and indicates the position margin admitted
for the synchronization to be OK.
LIMIT+
LIMIT-
Axis travel limits.
Both parameter should be set to a value other than ·0·.
TENDENCY Activation of tendency test. It detects axis runaway due to positive feedback.
It should be activated during machine setup.
PROBERANGE Maximum braking distance.
This parameter sets the maximum braking distance for the probe after
probing to avoid breaking it (ceramic, etc).
PROBEFEED Maximum probing feedrate.
PROBEDELAY
PROBEDELAY2
Delay for the probe 1 and 2 signal. This parameter is only set when there is
a short delay from the probing instant to when the CNC actually receives the
signals (infrared communication, etc.).
REPOSFEED Repositioning feedrate after a tool inspection.
POSFEED Positioning feedrate of the independent axis.
JOGFEED JOG mode. Feedrate in continuous jog mode.
JOGRAPFEED JOG mode. Rapid feedrate in continuous jog mode.
MAXMANFEED JOG mode. Maximum feedrate in continuous jog mode.
MAXMANACC JOG mode. Maximum acceleration in JOG mode.
INCJOGFEED JOG mode. Feedrate in incremental jog mode.
FBACKAL Feedback alarm activation.
The feedback alarm must be activated.
G00FEED Feedrate in G00.