Fagor CNC 8060 - Variables Related to OEM Machine Parameters

·684·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to OEM machine parameters.
10.12 Variables related to OEM machine parameters.
GENERIC OEM PARAMETERS.
(V.)MTB.SIZE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of OEM parameters.
(V.)MTB.P[i]
Variable that can be read and written via program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Value of the OEM parameter [nb]
Syntax.
·nb· Parameter number.
Remarks.
When reading this variable from the PLC, it truncates the decimal side. If the value of the
parameter is 54.9876, when read from the PLC, it will return the value 54.
It must be borne in mind that reading and writing these variables interrupts block preparation
affecting program execution time. If the value of the parameter is not going to be changed
during execution, it is recommended to read the MTB variables at the beginning of the
program using arithmetic parameters (local or global) and use the global ones throughout
the program.
(V.)MTB.PF[i]
Variable that can be read and written via program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Value of the OEM parameter [nb] Value per 10000.
Syntax.
·nb· Parameter number.
Remarks.
When reading this variable from the PLC, it returns the value in ten-thousandths. If the value
of the parameter is 54.9876, when read from the PLC, it will return the value 549876.
It must be borne in mind that reading and writing these variables interrupts block preparation
affecting program execution time. If the value of the parameter is not going to be changed
during execution, it is recommended to read the MTB variables at the beginning of the
V.MPB.SIZE
V.MTB.P[10] Value of the OEM parameter P10.
Machine parameter. Reading from the PLC.
MTB.P[0]
Reading from the PLC.
V.M TB .PF [0 ]
P0 = 54.9876 54 549876
P0 = -34.1234 -34 -341234
V.MTB.PF[10] Value of the OEM parameter P10.
Machine parameter. Reading from the PLC.
MTB.P[0]
Reading from the PLC.
V.M TB .PF [0 ]
P0 = 54.9876 54 549876
P0 = -34.1234 -34 -341234