Fagor CNC 8060 - PLC Modifiable Logic Signals; Independent Interpolator

·730·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; independent interpolator.
10.23 PLC modifiable logic signals; independent interpolator.
(V.)PLC._IXFERINHxn
If the PLC deactivates this mark, the movements of the independent axis remain waiting for
the PLC to activate this mark again.
Syntax.
·xn· Name or logic number of the axis.
(V.)PLC.IRESETxn
Variable that can be read and written from the program and interface and read from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the independent interpolator interrupts the instruction being
executed and eliminates the instructions pending execution.
Syntax.
·xn· Name or logic number of the axis.
(V.)PLC.IABORTxn
Variable that can be read and written from the program and interface and read from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the independent interpolator interrupts the positioning block
being executed (if any) eliminating also the rest of the positioning blocks pending execution.
Syntax.
·xn· Name or logic number of the axis.
V.PLC._IXFERINHX X axis.
V.PLC._IXFERINH3 Axis with logic number ·3·.
V.PLC.IRE SETX X axis.
V.PLC.IRE SET3 Axis with logic number ·3·.
V.PLC.IABORTX X axis.
V.PLC.IABORT3 Axis with logic number ·3·.