Fagor CNC 8060 - Page 729

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·729·
PLC modifiable logic signals; spindles.
(V.)PLC.PLCM3
(V.)PLC.PLCM4
(V.)PLC.PLCM5
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC turns this mark on to let the CNC know that it must execute the corresponding M
function at the indicated spindle.
(V.)PLC.SLIMITACSPDL
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
There is a mark for each spindle. The mnemonics for each spindle are the following:
SLIMITACSPDL1 (can also be programmed as SLIMITACSPDL)
SLIMITACSPDL2 SLIMITACSPDL3 SLIMITACSPDL4
If the PLC activates this mark, the CNC activates the speed safety limits (parameter SLIMIT)
on the indicated spindle.
V.PLC.PLCM3 Spindle ·1·.
V.PLC.PLCM3SP1 Spindle ·1·.
V.PLC.PLCM3SP2 Spindle ·2·.
V.PLC.PLCM3SP3 Spindle ·3·.
V.PLC.PLCM3SP4 Spindle ·4·.
V.PLC.SLIMITACSPDL Spindle ·1·.
V.PLC.SLIMITACSPDL1 Spindle ·1·.
V.PLC.SLIMITACSPDL2 Spindle ·2·.
V.PLC.SLIMITACSPDL3 Spindle ·3·.
V.PLC.SLIMITACSPDL4 Spindle ·4·.