Fagor CNC 8060 - Page 732

·732·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; tool manager.
(V.)PLC.MZTOCH1
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the magazine to the claw 1 of the
tool changer arm.
(V.)PLC.CH1TOSPDL
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the claw 1 of the tool changer arm
to the spindle.
(V.)PLC.SPDLTOCH1
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the spindle to the claw 1 of the
tool changer arm.
(V.)PLC.SPDLTOCH2
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the spindle to the claw 2 of the
tool changer arm.
V.PLC.MZTOCH1 Magazine ·1·.
V.PLC.MZTOCH1MZ1 Magazine ·1·.
V.PLC.MZTOCH1MZ2 Magazine ·2·.
V.PLC.MZTOCH1MZ3 Magazine ·3·.
V.PLC.MZTOCH1MZ4 Magazine ·4·.
V.PLC.CH1TOSPDL Magazine ·1·.
V.PLC.CH1TOSPDLMZ1 Magazine ·1·.
V.PLC.CH1TOSPDLMZ2 Magazine ·2·.
V.PLC.CH1TOSPDLMZ3 Magazine ·3·.
V.PLC.CH1TOSPDLMZ4 Magazine ·4·.
V.PLC.SPDLTOCH1 Magazine ·1·.
V.PLC.SPDLTOCH1MZ1 Magazine ·1·.
V.PLC.SPDLTOCH1MZ2 Magazine ·2·.
V.PLC.SPDLTOCH1MZ3 Magazine ·3·.
V.PLC.SPDLTOCH1MZ4 Magazine ·4·.
V.PLC.SPDLTOCH1 Magazine ·1·.
V.PLC.SPDLTOCH2MZ1 Magazine ·1·.
V.PLC.SPDLTOCH2MZ2 Magazine ·2·.
V.PLC.SPDLTOCH2MZ3 Magazine ·3·.
V.PLC.SPDLTOCH2MZ4 Magazine ·4·.