Fagor CNC 8060 - Page 733

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·733·
PLC modifiable logic signals; tool manager.
(V.)PLC.CH1TOMZ
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the claw 1 of the tool changer arm
to the magazine.
(V.)PLC.CH2TOMZ
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the claw 2 of the tool changer arm
to the magazine.
(V.)PLC.SPDLTOGR
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the spindle to ground.
(V.)PLC.GRTOSPDL
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the ground to the spindle.
V.PLC.CH1TOMZ Magazine ·1·.
V.PLC.CH1TOMZ1 Magazine ·1·.
V.PLC.CH1TOMZ2 Magazine ·2·.
V.PLC.CH1TOMZ3 Magazine ·3·.
V.PLC.CH1TOMZ4 Magazine ·4·.
V.PLC.CH2TOMZ Magazine ·1·.
V.PLC.CH2TOMZ1 Magazine ·1·.
V.PLC.CH2TOMZ2 Magazine ·2·.
V.PLC.CH2TOMZ3 Magazine ·3·.
V.PLC.CH2TOMZ4 Magazine ·4·.
V.PLC.SPDLTOGR Channel ·1·.
V.PLC.SPDLTOGRC1 Channel ·1·.
V.PLC.SPDLTOGRC2 Channel ·2·.
V.PLC.SPDLTOGRC3 Channel ·3·.
V.PLC.SPDLTOGRC4 Channel ·4·.
V.PLC.GRTOSPDL Channel ·1·.
V.PLC.GRTOSPDLC1 Channel ·1·.
V.PLC.GRTOSPDLC2 Channel ·2·.
V.PLC.GRTOSPDLC3 Channel ·3·.
V.PLC.GRTOSPDLC4 Channel ·4·.