·734·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; tool manager.
(V.)PLC.MZTOSPDL
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the magazine to the spindle.
(V.)PLC.SPDLTOMZ
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on after taking the tool from the spindle to the magazine.
(V.)PLC.MZROT
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to rotate the turret.
(V.)PLC.TCHANGEOK
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on when the tool change is done.
V.PLC.MZTOSPDL Magazine ·1·.
V.PLC.MZTOSPDLMZ1 Magazine ·1·.
V.PLC.MZTOSPDLMZ2 Magazine ·2·.
V.PLC.MZTOSPDLMZ3 Magazine ·3·.
V.PLC.MZTOSPDLMZ4 Magazine ·4·.
V.PLC.SPDLTOMZ Magazine ·1·.
V.PLC.SPDLTOMZ1 Magazine ·1·.
V.PLC.SPDLTOMZ2 Magazine ·2·.
V.PLC.SPDLTOMZ3 Magazine ·3·.
V.PLC.SPDLTOMZ4 Magazine ·4·.
V.PLC.MZROT Magazine ·1·.
V.PLC.MZROTMZ1 Magazine ·1·.
V.PLC.MZROTMZ2 Magazine ·2·.
V.PLC.MZROTMZ3 Magazine ·3·.
V.PLC.MZROTMZ4 Magazine ·4·.
V.PLC.TCHANGEOK Magazine ·1·.
V.PLC.TCHANGEOKMZ1 Magazine ·1·.
V.PLC.TCHANGEOKMZ2 Magazine ·2·.
V.PLC.TCHANGEOKMZ3 Magazine ·3·.
V.PLC.TCHANGEOKMZ4 Magazine ·4·.
To Next Page
Loading...
